Spraying chocolate, and why the viscosity figures mislead.

Melted chocolate has a published viscosity that looks far beyond what a sprayer should manage, yet it sprays cleanly. The reason is shear, and once you understand it the cocoa butter ratios and working temperatures make a lot more sense.

Chocolate is the material most often assumed to be beyond a sprayer, because the published viscosity figures appear to rule it out. Those figures are measured in a way that does not represent conditions at the nozzle.

Why chocolate breaks the rule.

Water, oil and egg wash behave much the same at rest as they do when forced through a nozzle. Melted chocolate doesn’t. It’s pseudoplastic, or shear thinning: the harder you work it, the thinner it behaves.

Published chocolate viscosities are apparent figures measured at very low shear, and a DIN cup measures flow under gravity, which is about as gentle as it gets. A nozzle does the opposite, and under that shear the viscosity falls sharply. The static figure therefore overstates the resistance the nozzle encounters, which is why the foodSPRAY Pro sprays neat chocolate, one hundred per cent couverture with nothing added.

Cocoa butter is about the finish, not the spraying.

Cocoa butter is added for spraying, usually half and half or 60 to 40, to change the finish rather than to make it sprayable, because the extra cocoa butter is what gives a velvet effect its fine structure. The more cocoa butter, the finer the structure.

Our chocolate sprayer was developed with Barry Callebaut to run that mixture at 28 to 35°C, and the heated nozzle stops the chocolate setting rather than forcing it through. Pure cocoa butter is the opposite problem, thin enough that it takes our smaller R4 nozzle to atomise it finely.

Working ratios

MixtureTemperatureResult
Neat couvertureWorking temperatureSprays through a professional piston sprayer with nothing added
50% chocolate, 50% cocoa butter28 to 35°CThe standard velvet mixture, developed with Barry Callebaut
60% chocolate, 40% cocoa butter28 to 35°CAlso widely used, slightly less fine in structure
100% cocoa butter28 to 32°CVery thin, needs the smaller R4 nozzle for a fine result

Ratios as used in professional practice. Always apply to a frozen surface for the velvet effect, since the thermal shock is what creates the texture.

Tempering and temperature.

Use tempered couverture for spraying. If you spray untempered chocolate in a thick coating, you run the risk that it will not crystallise the way you want it to.

Chocolate is solid at room temperature and will not spray in that state. Warmed to its working temperature it sprays cleanly. The heating on a chocolate sprayer exists to keep the material fluid on its way through the nozzle, and the insulation on the container slows the rate at which the material cools while you work.

What will not spray.

Honey and treacle are the real exceptions. They don’t shear thin, so working them harder doesn’t make them flow, and they won’t atomise at any pressure. Those need a different technology such as ultrasonic. Everything else in a kitchen sprays, given the power and the right working temperature.

What this means when you buy.

A sprayer quoted only on its pressure figure tells you very little about chocolate, because the material’s behaviour under shear matters more than any static number. What matters is whether the sprayer is a piston design with enough power, whether the nozzle is engineered to atomise, whether the nozzle can be heated to stop the material setting, and whether the whole food contact area comes apart for cleaning afterwards.

As with any equipment that touches food, request the Declaration of Conformity before purchase.

The professional tool

Chocolate, neat or cut.

A heated nozzle to stop it setting, the power to atomise it, and a food contact area that comes apart in a minute.